help in developing coova !!!!
oguzhank at bilkent.edu.tr
Wed Oct 14 12:33:37 UTC 2009
I fund a hint that can make my work much more easier..
The problem is it allows only from dynamic pool addresses.
It can be so so great if there were a paremeter called uamstatanyip to
make static ip assigments available only for staticip pool.
Or an overwrite of framed-ip-pool parameter if the ip is within the range of
dynamic or static pool.
Or if whoever developing that part of the system, can give me a hand to
figure out the parameters,so i can take part in writing that patch for
> As i read on the forums and according to my own needs, we are planning to
> develop an option on coova.
> What we need is as i previosuly write on this email list.. We need to
> reserve some ip addresses and set them to some macids also to be able to
> use some staticip devices on coova network like printers switches etc..
> As far as i see there are a couple of problems and options.
> First of all, it is unable to use staticip pool without enabling uamanyip
> parameter. But enabling this, also enables the client set ip addresses
> outside of stat and dynamic ip pools.
> Solution might be creating a localfile with some macids=ipaddresses and
> coova should reserve this ip addresses fr this macids even it is in
> dynamic pool.
> Or allowing to give static ip addresses if ip is on staticip pool even
> uamanyip parameter is off.
> Or only allowing staticip pool to be used if the ip address is set by
> radius by framed-ip-address parameter.(sure anyip parameter off again)
> So what i am asking is a little help on which solution is much more useful
> for coova community..and also where should i start.. is the solution lies
> on editing ippool.c or dhcp ??
> I am asking this because editing the source just according to my needs
> wont help coova community itself much.
> Any ideas will be appreciated..
> To unsubscribe, e-mail: chilli-unsubscribe at coova.org
> For additional commands, e-mail: chilli-help at coova.org
More information about the Chilli